$TXT Created by FISHER,BRAD at DEVVFF.FO-ALBANY.MED.VA.GOV  (KIDS) on Friday, 04/19/13 at 13:41
=============================================================================
Run Date: MAY 14, 2013                     Designation: EDP*2*5
Package : EDP - EMERGENCY DEPARTMENT          Priority: EMERGENCY
Version : 2         SEQ #2                      Status: Released
                  Compliance Date: MAY 16, 2013
=============================================================================


Subject: EDP*2*4 CORRUPTION RESOLUTION

Category: 
  - PATCH FOR A PATCH
  - Routine

Description:
============

 Associated patches: EDP 2.0       <<= must be installed BEFORE 'EDP*2*5'
   
  
 This PATCH FOR A PATCH addresses the below issue, as well as a
 corruption issue encountered with EDP*2.0*4. During the release process
 routine EDPFPTC had been corrupted in the development environment
 causing the routine to be incorrect at the time of release. This patch
 resolves the logic issues within EDPFPTC.
   
 This EMERGENCY patch addresses an issue in EDIS that causes errors in
 routine XOBVSKT when selecting a patient with multiple Patient Record
 Flags (PRF's) with multiple lines of text in more than one of the flags.
  
 This patch contains a single routine (EDPFPTC), and contains no other
 patch components.
   
   
 Patch Components
 ================
  
 Remedy Ticket(s) & Overview
 ---------------------------
   
 1.   #INC000000841991 - Error message Loading log entries failed.
                         Error number 1085.
  
 Problem:
 --------
 Patch was installed last night and now users are unable to remove any
 patients who were on the board that were on the board at the time of
 the patch was installed and patients that were added after the patch
 was installed cannot be updated.  Error message Loading log entries
 failed.  Error number 1085.
  
  
 Resolution:
 -----------
  
  EDP*2.0*4 was released with an incorrect version of EDPFPTC. The section
  of logic in EDPFPTC related to patch 4 is as follows:
  
  . F  S N=$O(EDPY(EDI,"NARR",N)) Q:N<1 S 
 X=X_$C(13,10)_$G(EDPY(EDI,"NARR",N,0))
  . ;F S N=$O(EDPY(EDI,"NARR",N)) Q:N<1 S X=$G(EDPY(EDI,"NARR",N,0)) D 
 XML^EDPX(X)
  . ;bwf - 3/1/2013 - removed line due to multiple flag issues
  . D XML^EDPX("<text>"_$$ESC^EDPX(X)_"</text>")
  . ;bwf 3/1/2013 - added following line to build footer for patient 
 record flag issues.
  . ;D XML^EDPX("</text>")
  
  
  EDP*2.0*5 corrects the logic to be the following:
  
  . ;F S N=$O(EDPY(EDI,"NARR",N)) Q:N<1 S 
 X=X_$C(13,10)_$G(EDPY(EDI,"NARR",N,0))
  . F  S N=$O(EDPY(EDI,"NARR",N)) Q:N<1 S X=$G(EDPY(EDI,"NARR",N,0)) D 
 XML^EDPX($$ESC^EDPX(X))
  . ;bwf - 4/16/2013 - removed line due to multiple flag issues
  . ;D XML^EDPX("<text>"_$$ESC^EDPX(X)_"</text>")
  . ;bwf 4/16/2013 - added following line to build footer for patient 
 record flag issues.
  . D XML^EDPX("</text>")
  
 Associated Remedy Tickets:
 --------------------------
  
 842002
 842007
 842019
 842029
 842034
 842043
 842045
 842059
 842092
 842102
 842115
 842118
 842120
 842149
 842158
 842170
 842206
 842207
 842208
 842209
 842217
 842229
 842278
 842294
 842298
 842300
 842307
  
  
 2.   #INC000000773607 - Cannot do anything with patient on board - 
                         receive error.
   
 Problem:
 -------
 Multiple Patient record flags causing patient to be inaccessible in EDIS.
   
 Resolution:
 ----------
 Modified EDPFPTC routine to build XML in a more friendly way to XOBVSKT. 
 The old logic would build the xml in a structure where there were 
 $C(13,10) values imdded and a single line was used to create the XML.
 Ex. <text> Record flag info line 1_$C(13,10)_line 2_$C(13,10)_$C(13,10) 
 </text>
  
 The modification builds the xml so that each line of text is represented 
 in the xml as the body.
   
 Ex.
 <text>
 Record flag info line 1
   
 line 2
 </text>
   
 Test Sites:
 ----------
 Baltimore
 New York Harbor
 Lebanon
 Syracuse
   
 Associated Remedy Tickets:
 --------------------------
 755918
 770503
 778925
 779546
 780003
 780200
 781201
 791172
 795159
 796082
 796334
 800480
   
 Documentation Retrieval Instructions
 ------------------------------------ 
 N/A
   
 Title                         File Name                       FTP Mode
 -----------------------------------------------------------------------
 N/A
   
 Patch Installation:
   
   
 Pre/Post Installation Overview
 ------------------------------
 N/A
   
 Installation Instructions
 -------------------------
 This patch may be installed with users on the system although it is 
 recommended that it be installed during non-peak hours to minimize
 potential disruption to users.  This patch should take less than 5 
 minutes to install.
  
 *************************************************************
 Important Note:
  
 The BEFORE checksum for routine EDPFPTC is based on EDP*2*4, which
 has been marked as 'Entered In Error'. It is okay if the before
 checksum in the patch does not match the checksum in your test or
 production environments. Please insure that the post patch checksum
 for EDPFPTC matches.
  
 Checksums calculated by FORUM:
  
 Before: B18942481   After: B19115099  **5**
  
 The Checksums you MAY see when installing EDP*2*5:
  
 Before: B14885802   After: B19115099  **5**
  
 *************************************************************
  
   
 Installation Instructions
 -----------------------------
 1.  Choose the PackMan message containing this patch.
   
 2.  Choose the INSTALL/CHECK MESSAGE PackMan option.  
   
 3.  From the Kernel Installation and Distribution System Menu, select
     the Installation Menu.  From this menu, you may elect to use the
     following option. When prompted for the INSTALL enter the patch #(ex.
     EDP*2.0*5):
   
     a.  Backup a Transport Global - This option will create a backup
         message of any routines exported with this patch. It will not
         backup any other changes such as DDs or templates.
     b.  Compare Transport Global to Current System - This option will
         allow you to view all changes that will be made when this patch
         is installed.  It compares all components of this patch
         (routines, DDs, templates, etc.).
     c.  Verify Checksums in Transport Global - This option will allow
         you to ensure the integrity of the routines that are in the
         transport global.
       
 4.  From the Installation Menu, select the Install Package(s) option and
     choose the patch to install (EDP*2*5).
   
 5.  When prompted 'Want KIDS to Rebuild Menu Trees Upon Completion of
     Install? NO//', answer 'NO'     
      
 6.  When prompted 'Want KIDS to INHIBIT LOGONs during the install?
     NO//', answer 'NO'.
   
 7.  When prompted 'Want to DISABLE Scheduled Options, Menu Options, 
     and Protocols? NO// , answer 'NO'.
   
 8.  If prompted "Delay Install (Minutes):  (0 - 60): 0// respond 0.
   
   
 Post-Installation Instructions
 ------------------------------
 N/A

Routine Information:
====================
The second line of each of these routines now looks like:
 ;;2.0;EMERGENCY DEPARTMENT;**[Patch List]**;May 2, 2012;Build 18

The checksums below are new checksums, and
 can be checked with CHECK1^XTSUMBLD.

Routine Name: EDPFPTC
    Before: B18942481   After: B19115099  **5**

=============================================================================
User Information:
Entered By  : FISHER,BRADLEY                Date Entered  : APR 16, 2013
Completed By: SHANE,CLARK                   Date Completed: MAY 08, 2013
Released By : VANCAMP,E PHILIP              Date Released : MAY 14, 2013
=============================================================================


Packman Mail Message:
=====================

$END TXT